We always appreciate hearing if someone has found a mistake in one of my patterns. We do our best to issue corrections and post the errata here. If there is a mistake in a printed pattern we can only correct it on a subsequent print run. Therefore printed patterns with mistakes might still be floating around out there. In any case, the following list are those pattern corrections that we know of and we hope these notes help you. We apologize for any inconvenience or frustration a mistake has caused- we really do try our darnedest to avoid them! :)
If you think you have found a mistake that isn't listed here or need pattern support, please write to info@annamariapatterns.com.
Page 7 / Sewing Section / Step 4 should read:
Each of these four pieces can be opened to their right sides to reveal an HST. Press seam allowance towards darker of the two fabrics. Trim these HSTs to be 4 ¾” square if necessary.
Page 9 / Sewing Section / Step 5 should read:
Repeat Steps 2-4 to attach a second square to the left side of the unit. This second line of sewing will overlap the first at the top center which is necessary. This unfinished Flying Geese unit should measure 4 ¾” x 9 ½”
Cutting Instructions:
Step 7, next to last instruction for (E) should read as:
-(E) two rectangles measuring 3 1/2” x 5”
Step 14, second instruction should read as:
-(E) two squares measuring 5 1/2” x 6 1/2” with two yellow fowers off center
Section K (next to last page)
Opening remarks should read as:
Section K (make four) Assembled but unfnished sections should measure 3 1/2” x 72 1/2”
Page 4 / Cutting for Whole Blocks, Corners & Borders / Step 4 should read:
Cut two 11.5” squares from feature fabric for blocks H, then sub cut both from one corner to the opposite corner so that you end with four corner triangles.
